A free stamping resource!

Gift Can Holiday Blizzard

 

By Debbie Ebat, Artistic Guide

Finished size:  4.5 inches tall,  12.5 inches around

Supplies:
For the Can:
Stamp
Snow Animals-Stamps Happen

Paper
White  Paper Temptress

Frosty Cabin paper pad by Recollections
Ink
Memento Tuxedo Black Tsukineko

Copic markers
Deer

E21, E23, E25, E50
C9, C0, C3
R20, R21
YG07, YG23, YG45
Owl
E50, E53, E55
Bunny
C0, C00, C1, C2
R20, R21, R24, R27, R29, R37, R46, R43. R56
B91, B93, B97
Bear
C00,
R20, R22, R24, R27, R29
G40, G43, YG45
E11, E13, E15, E50
B91, B93,B97
Snow
B0000
W0, W00
Other
Measuring tape

Red adhesive tape Recollections
Resplendent Rectangle Spellbinders
Grand Calibur Spellbinders
Glitter Dots Recollections
Christmas Ribbon Celebrate it Michael's
Glitter Pen Gelly Roll
Can

For the Lid
Stamp
Stampin' up saying

Ink
Memento Tuxedo Black Tsukineko

Paper
White Paper Temptress

Red from my stash
Other
Circle Spellbinders dies

Martha Stewart Stickers EK Success
Art Glitter dries Clear adhesive
Red ribbon scrap
Copic marker R29

Directions

The can I  used for this project was an empty hot chocolate can 1 lb  size.  I removed the paper and cleaned the can.  I measured around the can and the height of the can, which was 4.45 X 12.5 inches

 Then I wrapped the red tape around the top and the bottom of the can.  With two pieces running from top to bottom.

 I took a sheet of 12 X 12 paper and cut it to 4.45 inches  and did a second cut   that 4.45  by 4 inches.  Then I carefully stuck the paper to the can.. .do this slowly so you will not go crooked or have lumps.

 The can was a little bigger then the 12 inch paper so I had to put in a panel on the backside

 Then I wrapped a Christmas ribbon around the can.

 Next, I stamped my image and colored with Copic markers.

 This image was cut out using a Spellbinders die and then taped to the side of the can, with  a little glue added to stick the ends down.

 Now on to the lid... the lid was gold and that just would not do. I used my Spellbinders dies for circles,  picking the one that best suited the size of the lid.  I cut out 2 circles then did a frame.

 This was layered on to a red circle.  To make the frame you use two spellbinders dies and cut them out at the same time.

This is  the result.

I glued the frame on the outer ring of the lid.  Then I added the red circle and then the white stamped circle.

This was all stuck to the lid using my favorite glue which is Art Glitter dries clear.

 Next I added ribbon around the outer ring of the lid again using glue.

 Then I added stickers to decorate.

 Here are some additional views of the finished can.


The great thing about this project is you can use most any size can and decorate it.  You could take a can of nuts or candy and make is something a little more special.. but they might not want to open it.

Thanks! I hope I have inspired you to try this.

Debbie

 



Tagged as: , , , , , , , , , , , , , , , ,

1 Responses »